TCU TurboLamik

Hi Richard how do you configure the tcu for the push button gear change Iv been looking at that myself

Big thanks to the guys at Turbolamik Poland for programming my TCU remotely, I’m not that good with all the tech stuff so I kept putting of trying to do it but the Turbolamik support team helped me through it and made it seem so simple l don’t know what I was worried about ,thanks so much Turbolamik ...

Jar wrote: 25 Feb 2025, 11:09 why don't you write to technical support? they do it remotely and for free...

https://turbolamik.eu/contact/

thanks i will do that

Is there anyone not to far away from Stansted Airport that I can pay to program my Turbolamik tcu for me,
I am also using a Holley up ecu that I have a canbus connection with,
Engine is a Chevy ls3 gearbox is Jaguar 8hp 70

Hey Gary, that looks amazing.

I've just picked up an RX8 with Chevy L83 running an Emerald ECU and 8HP on a Turbolamik, I'm afraid I'm completely new to this as well and I live in Lincoln so a few miles away but will share what little I learn as I go.


Hi Richard I’m at the point of giving up ...

Pleas help
I am having trouble with the down load,when I press upload current bin to emulator a blue box comes up on the bottom bar says upload and the turbolamik LCD also says upload but it doesn’t seem to be doing anything even after 30 minutes ,
Then when I shut it all down and turn the ignition ...

Hi i live in Essex in the UK
Are the any other turbolamik users in the South East i think i am going to need some help in the programing or maping ,
iv got it all in the car and wired up and canbus wires to my Holley hp ecu
the engine is a Chevy LS3.

https://forum.turbolamik.https://forum ...

Check "enable dual emulator 16bit" in settings. Should be disabled to properly work


Thanks that fixed the problem,
but now im stuck on trying to conect the Canbus between my Holley hp ecu and the turbolamik tcu ,the manual dosent seem to say anything about this,
I have managed to update the ...

I am having trouble with the installation and connection. i get to the point where the dash panel is displayed and reading what the gesarbox is doing with the blue DA connected box displayed but still get hardwear not found in the box to the left of it, I can't seem to get any further with it ...