Hi everyone.
I just finished up soldering in a board and have connected the lamik and a harness to check my work. valve body makes noises when turned on but no program switch. I turn it but the lcd doesnt change. Only error in 33.
Have I missed something simple in tunerpro or did I stuff something up in mechatronics?
I have connected 2 power and 2 earth on lamik tcu loom.
I have uploaded an e90 8hp70 petrol base map from here.
I have DCT shifter not connected yet (not sure which wires to connect to yet)
Any help appreciated.
Thank you
First timer and maybe having problems
-
jaisout
- Posts: 1
- Joined: 23 May 2023, 07:50
First timer and maybe having problems
You do not have the required permissions to view the files attached to this post.
-
MeMpHiSj
- Posts: 39
- Joined: 03 Aug 2022, 11:31
Re: First timer and maybe having problems
Check error list table, comes with tcu, then you understand what wrong 
@E60 525d LCI stage3 turbosystems + 8hp75 RWD turbolamik
-
2jz
- Posts: 4
- Joined: 16 Sep 2022, 17:10
Re: First timer and maybe having problems
If I remember correctly program mode change does not work when DTC 033 (vehicle CAN error) is active. I was also wondering when I tested my setup on the bench. Nothing to worry about.