No rpm on startup

Post Reply
Laurits_joergensen
Posts: 1
Joined: 29 Oct 2026, 22:15

No rpm on startup

Post by Laurits_joergensen »

Hello

I am having this issue where it don't get an engine rpm signal into my turbolamik, and no fault code is shown. Then after 5-10 of blipping the throttle I suddenly get an rpm signal, but I also get a fault code 019.
I am using a hall effect sensor on the crankshaft with a 60-2 wheel

Engine speed input filtering is set to 58
Engine speed input (tooth count) is set to 58
Input voltage is set to 2.3V
Pull-up resistor 2.2K ohm is set to on
Sensor input is on pin 65
5V out is from pin 62
Sensor ground is on pin 17

There is also a fault code history with a 019 and a 033, do they effect anything?

Can anyone help me with this problem
M4comp
Posts: 127
Joined: 26 Jun 2024, 03:21

Re: No rpm on startup

Post by M4comp »

so there is a few things to check;

The first being the sensor you're using. You have noted 3 wires used so this will make it a hall sensor but are you sure it's a 5v sensor? Just confirming

The one thing that gets lots of people is ensuring you write to the TCU after every change in TunerPro.


View -> Toolbars -> Data Acquisition Send Command
This will give you a new toolbar that you can click 'send' and clear codes while the TCU is powered up. You'll find it at the top of TunerPro (drop down menu next to the send button).


Under Sensor Cal -> Sensor Input ->Engine RPM Input
This should equal 2 to enable the TCU RPM input.


Under Sensor Cal -> Sensor Input -> Analog Engine Speed -> Engine Speed Input Pull UP & Down
This will need to be checked with a voltmeter. You need to verify the sensors output. You will have 3 choices, either both off, pull-UP ON or pull-Dwn ON. You can only use 1


Under Sensor Cal -> Sensor Input -> Analog Engine Speed -> Engine Speed Input Sensitive Voltage
This needs to be set based on the sensors output voltage. You'll need to verify this voltage while cranking.
Post Reply