TCU TurboLamik

Hi everyone.
I just finished up soldering in a board and have connected the lamik and a harness to check my work. valve body makes noises when turned on but no program switch. I turn it but the lcd doesnt change. Only error in 33.
Have I missed something simple in tunerpro or did I stuff something up in mechatronics?
I have connected 2 power and 2 earth on lamik tcu loom.
I have uploaded an e90 8hp70 petrol base map from here.
I have DCT shifter not connected yet (not sure which wires to connect to yet)

Any help appreciated.
Thank you

Check error list table, comes with tcu, then you understand what wrong

If I remember correctly program mode change does not work when DTC 033 (vehicle CAN error) is active. I was also wondering when I tested my setup on the bench. Nothing to worry about.