TCU TurboLamik

Hi guys,

New to the forum - so hello!

Have just connected my TCU 2.0 for the first time -

Issues I have:

In the tunerpro software - I have followed the TCU set up instructions - checking port settings for cable - sharing with emulator etc

When I click acquire data a DA connecting - doesn’t load (stays orange)

When I click initialize emu hardware - response is ‘hardware not found’


Things I have checked:

Port settings correct -

12.5v to TCU and grounded

Latest tunerpro software

10.6 XDF & ADX lodaded into tuner pro software?



Please help if you can - complete newb.


Thanks
Matt

Other things I’ve checked:

Continuity between pin out from harness connector and chassis ground (all good 001) - while harness not connected to TCU.

Continuity between sensor ground (spade connector I installed to connect to paddles) to chassis ground - 1542?!

Not sure if there’s meant to be continuity between the sensor ground and chassis ground whilst the harness is connected to the TCU. But there isn’t any.


Could that mean there’s an issue with the TCU? - or is that meant to be the expected continuity.



Next check:

12v supply - checked pin out for main 12v supply - power present at 12.5v

Checked pin out for ignition - 12.5v there too.





At this point I’m pretty stumped so hopefully it’s not a hardware fault and hopefully it’s just something I’m getting wrong with the software.




Thanks again - in advance.

Are the com port settings correct? in device manager & tuner pro interface setup?

Yeah com port settings correct and downloaded new FTDI driver compatible with windows 11 laptop which I’m using.