Page 1 of 1
Code 33 after can2 hook up?
Posted: 22 Dec 2023, 03:06
by 75z28
Quick question(hopefully) about Holley EFI to turbo lamik can connection
Got the computer wired up, oil temp and code 33...
I have the computer wired to a terminator x max using j3 pins 14 and 20. I went into the tuner pro software and changed can2 to 10 for holley efi.
Still getting code 33(i tried swapping pins and that didn't work).
Any suggestions?
Note the engine isn't running since I am waiting to install the trans completely(adaptor was not correct)
I have tried changing holley can protocols between 6l80 racepak and holley standard... Still not working.
Re: Code 33 after can2 hook up?
Posted: 25 Mar 2024, 19:38
by ruiipinheiroo
75z28 wrote: 22 Dec 2023, 03:06
Quick question(hopefully) about Holley EFI to turbo lamik can connection
Got the computer wired up, oil temp and code 33...
I have the computer wired to a terminator x max using j3 pins 14 and 20. I went into the tuner pro software and changed can2 to 10 for holley efi.
Still getting code 33(i tried swapping pins and that didn't work).
Any suggestions?
Note the engine isn't running since I am waiting to install the trans completely(adaptor was not correct)
I have tried changing holley can protocols between 6l80 racepak and holley standard... Still not working.
Check if you have between the two wires of the CAN BUS 60 Ohm. If you don't you need to "close" your CAN BUS with terminator resistances.
Re: Code 33 after can2 hook up?
Posted: 04 Apr 2024, 21:54
by 75z28
ruiipinheiroo wrote: 25 Mar 2024, 19:38
75z28 wrote: 22 Dec 2023, 03:06
Quick question(hopefully) about Holley EFI to turbo lamik can connection
Got the computer wired up, oil temp and code 33...
I have the computer wired to a terminator x max using j3 pins 14 and 20. I went into the tuner pro software and changed can2 to 10 for holley efi.
Still getting code 33(i tried swapping pins and that didn't work).
Any suggestions?
Note the engine isn't running since I am waiting to install the trans completely(adaptor was not correct)
I have tried changing holley can protocols between 6l80 racepak and holley standard... Still not working.
Check if you have between the two wires of the CAN BUS 60 Ohm. If you don't you need to "close" your CAN BUS with terminator resistances.
Just to update this, I tried literally everything with it and it never worked. This is due to not having support for terminator x