TCU TurboLamik

Hi all

I am new to the forum and busy with my first turbolamik installation, I have an 8HP70 out of a 2018 Range Rover sport and the mechatronics unit is different to anything I can find online or on this forum. I have compared the valve body with that of an older 8Hp and they seem identical. I am sure this mechatronics unit is easily modifiable as you have direct access to the wires and the ryutech board is not required. I dont want to sit and pin every wire to figure out what needs to be connected if someone has already done this. Your help will be greatly appreciated. I have attached a picture of the mechatronics unit.

The TCM from your gearbox is not suitable for modification under the TCU. the round plug does not have all 16 pins.
The regular TCM from the BMW gearbox fits and you can use it