TCU TurboLamik

Hi

Can I use my Edelbrock ProFlo 4 Can Bus Data stream to communicate with the Turbolamik TCU?

If so it would give me RPM, TPI etc etc

Details of the Edelbrock Can Bus are attached in a PDF document.

Thanks

I've never tried a custom can setup but in theroy yes it should work since your RPM, MAP and TPS share the same identifier...

Under 'CAN' -> 'Can2 (Engine)' -> 'Can2A Type CAR' = 7
'CAN' -> 'Can2 (Engine)' -> 'Can2 Speed' = 4
'CAN' -> 'Can2 (Engine)' -> 'Can2B Sport ECU type' = 0

Under 'CAN' -> 'Can2 (Engine)' -> 'Custom Can RX', you would set your CAN id to 768 (assuming the listed id is hex) and set your RPM, MAP and TPS byte positions. Then play with the offsets/muliplers to get the data to match the ECU's.