TCU TurboLamik

Hello.
Can I get some help with setup of the can-bus flags on byte 4, mainly I want to have the transbrake signal in, but not sure Wich bit mask I should use.
I have gotten the temperature, gear, program to work Tru can, but have never tried having flags on the same byte.
Best regards Henrik

Got it to work with the settings in this picture, but it's kinda hard to log the signals in the maxxecu without assigning an output.
So my transbrake signal needed a output for transbrake solinoid not be able to see if it's on or off.
Need to play with it some more.

need use

viewtopic.php?f=20&t=27