TCU TurboLamik

Recently picked up this track based car, basically a finished car but some small improvement projects for me to do. The car currently has a BMW shifter which works fine but doesn't quite feel right for a track car so while I'm in the USA for a couple of weeks I've picked up the following courtesy of Greg at Turbolamik US:
Can't wait to get home now to start the improvement projects.

Hi Richard how do you configure the tcu for the push button gear change Iv been looking at that myself

Hi Gary,

I've made the mount for the shifter but haven't got round to the keypad yet, I hope to do some testing this week with it just loosely wired to get it working before deciding on final fit location.

The keypad is large however, I think the smaller version from Blink Marine with 15mm buttons would be better although there's only the choice of 4 or 6 buttons in the smaller format.

Richard

Hi Gary,

Just doing some testing tonight, I just have the DCT shifter connected and set position 8 of the rotary switch to engage park when the vehicle is stopped. I think I will leave it like this for a while and see how I get on, I like the clean installation without a load of additional buttons.

Richard