First start 8hp70
First start 8hp70
Hey Guys, I finished installing the 8hp70 N57 into my 1993 Toyota Supra. I downloaded THE XDF, ADF & N57 petrol basemap and loaded it into the turbolamik. I filled the transmission with some fluid and I'm looking to do the first start up, so I can fill the transmission with the car running. I beleive I have the CAN set up properly for the Ecumaster black as the 033 error code went away. Is there anything I should look out for? or you recommend I do or check before starting the car for the first time?
Re: First start 8hp70
If you have just downloaded the files from the turbolamik site. You should verify the firmware matches the file you have.
In tunerpro connect to TCU while powered up (engine off for now) and enable live data. Look in the bottom left of tunerpro and make sure your firmware is at 10.74. If it's 10.73 or less you should up date to the version your based file is using.
In tunerpro - If you look in Transmission Cal -> Clutch Slipt Strategy -> and you have 'Enable semi slipt strategy' listed I would upgrade the firmware to 10.74. Then reflash the tune file your using.
In tunerpro connect to TCU while powered up (engine off for now) and enable live data. Look in the bottom left of tunerpro and make sure your firmware is at 10.74. If it's 10.73 or less you should up date to the version your based file is using.
In tunerpro - If you look in Transmission Cal -> Clutch Slipt Strategy -> and you have 'Enable semi slipt strategy' listed I would upgrade the firmware to 10.74. Then reflash the tune file your using.