TCU TurboLamik

Hey guys I have a quick question, turbo lamik was successfully up and running for 1 day then then suddenly it is locked in p1 and wont let me change out of that program. no error codes on display, i tried power reset several times and its not resolving the issue. any ideas are appricated thanks. all software xdf and adx files are current 10.74.

Have you checked the analogue input value is changing when switching between positions on the rotary switch? (Assuming you are using the rotary switch for program selection)

yes its active in Park and N you can selects gears but when you switch to drive it reverts back to P1. I am going to down load and re load the current bin see if that clears it. I am a new user so there is a learning curve.

If you are in 'normal' mode on the shifter the program value won't change. You need to be in sport or manual mode to change p number