No rpm on startup
Posted: 29 Oct 2026, 22:34
Hello
I am having this issue where it don't get an engine rpm signal into my turbolamik, and no fault code is shown. Then after 5-10 of blipping the throttle I suddenly get an rpm signal, but I also get a fault code 019.
I am using a hall effect sensor on the crankshaft with a 60-2 wheel
Engine speed input filtering is set to 58
Engine speed input (tooth count) is set to 58
Input voltage is set to 2.3V
Pull-up resistor 2.2K ohm is set to on
Sensor input is on pin 65
5V out is from pin 62
Sensor ground is on pin 17
There is also a fault code history with a 019 and a 033, do they effect anything?
Can anyone help me with this problem
I am having this issue where it don't get an engine rpm signal into my turbolamik, and no fault code is shown. Then after 5-10 of blipping the throttle I suddenly get an rpm signal, but I also get a fault code 019.
I am using a hall effect sensor on the crankshaft with a 60-2 wheel
Engine speed input filtering is set to 58
Engine speed input (tooth count) is set to 58
Input voltage is set to 2.3V
Pull-up resistor 2.2K ohm is set to on
Sensor input is on pin 65
5V out is from pin 62
Sensor ground is on pin 17
There is also a fault code history with a 019 and a 033, do they effect anything?
Can anyone help me with this problem