TCU TurboLamik

Hi

I want to use AUX for torque reduction.

I my case AUX9

Is it right that it is a Negative output?

I want so source the ground side of a relay.

Thanks

you can use AUX to reduce the torque, AUX 1 to 10 feed GND and AUX 11-12 feed + 12v. you can use any, TCU configuration question. If you understand correctly you want to use a relay? I advise against it, it will be too slow.

Okay, that was my fear.

What is better? I want to cut the coils..

Can you check my tcu file?

I need a ground signal for testing at AUX9 (54) but nothing comes out.

maybe a config error in it?

What is this car, ECU, Engine? I need to understand why you want to do this


"Torque Reduction>Output>Torque Reduction output value" you have it set to 0, change it to 95. The parameter is responsible for the output threshold.

It’s a MSS52 bmw S62B50 in E30

I want to cut the coil above 300nm a little.

I need a ground signal and adjustable cut Time

Are you sure with 95%??

100 % no torque reduction
0% Full torque reduktion

is written down

This is an error in the description
I have already corrected it and it looks like this

The output is active when the condition is met: "Torque Reduction Table" <"Torque Reduction Output Value"

Is this a new xdf file ?

I can’t show the folders.

Edit: got it