CAN settings for Motec M1 to TCU

[Lee Thompson]

Good day.
I need some help with CAN settings on both Motec M1 ECU and TCU.
CAN ID is set up correctly as the Error code 33 has now disappeared.
But at the dashboard i do not get readings for TPS,Engine pressure and RPM.

This is my first install,everything went easy up until CAN Comms.

Lee.

[M4comp]

Settings shown are for rx only, to enable tx you will need to setup a can id that you can transmit to from the TCU.
Enter that id you have selected and then select what analogs your sending