emu master classic to turbolamik

[snurbbo]

Hi.
I am having trouble getting the TQ reduction to work, using analog 2 out to get a signal to the ECU Master Classic.
But I can't get the signal to reach 5 volts and to give a signal when I am supposed to shift.
Shifting becomes a bit hard without flat shift or shift cut.

ecu master classic dont have canbus.

Regards Niklas

[M4comp]

I woud look at Torque Reduction Table "0" or 1, 2. If your not seeing the output trigger then this is most likely the issue. The value needs to be adjust to match your shift requirements. Have a look at values that are say 85 vs 50 when Torque Reduction Output threshold is = 88

Your ramp on off time and tq may be a bit to slow and need to adjust it. Make sure you not filtering the input on the Black

You can also enable the Reduction Test and use another input to activate it manually to test.


The most important bit make sure your on the correct output. There are 2, one that is an Analog found in Output -> Analog Outputs -> Torque Reduction analog out & the other is Torque Reduction -> Torque Reduction Output. One is an analog voltage and the other is ON/OFF (digital).