Reset adaptions

[chrisnexs]

Hi.
I changed mechatronic unit due of default.
Shifting is quite different now .
How can I reset the adaptions ?

[Jar]

To reset the adaptations to the factory read the content of the TCU and go to "Adaptation / Brake ADAP" and enter the value as in the picture below:

Brake ADAP.png (7.94 KiB) Viewed 1565 times

Save the settings with the floppy button and then go to "Save Parameters / Send Adapt. (Clone TCU)" and select SET, save and send to TCU.

SEND.png (6.9 KiB) Viewed 1565 times

Then repeat this step, this time uncheck SET and send to TCU.


"Send Adapt. (Clone TCU)" does that when you change settings and upload them to TCU, adaptations will not be taken into account from the file and will remain unchanged if after automatic adaptation they changed