CAN Keypad as selector?

[Renniks]

Hope someone can help! Did a quick search and haven't found an answer...

I'm planning to use a 6 key CAN Keypad instead of a BMW selector on my project. I assume its just a matter of configuring the keypad to output what the Lamik expects to see. Anyone able to shed some light on what would be needed?

Cheers

[Jar]

Ecumaster CAN Keyboard is supported, can be used as you like.

[Renniks]

Cheers! Thats actually the one I was looking at! didn't realise it was already supported.

Any idea where its all documented? Checked the ECUMaster section of the "Manual" subforum and couldnt see info regarding the keypad

[zeroto60]

just wanted to bump this if anyone has the info on setting up the can keypad for selector input

[Renniks]

just wanted to bump this if anyone has the info on setting up the can keypad for selector input

I'll be downloading the Tunerpro software soon and having a proper dig around to see if I can find any presets. Would certainly be nice to see the documentation though, rather than just risking it and buying all the hardware and hoping it works togeather

Edit: No luck. Think its gonna be buy it all and figure it out after!