Page 1 of 1
CAN Keypad as selector?
Posted: 30 Jan 2023, 02:00
by Renniks
Hope someone can help! Did a quick search and haven't found an answer...
I'm planning to use a 6 key CAN Keypad instead of a BMW selector on my project. I assume its just a matter of configuring the keypad to output what the Lamik expects to see. Anyone able to shed some light on what would be needed?
Cheers
Re: CAN Keypad as selector?
Posted: 03 Feb 2023, 10:43
by Jar
Ecumaster CAN Keyboard is supported, can be used as you like.
Re: CAN Keypad as selector?
Posted: 05 Feb 2023, 23:03
by Renniks
Cheers! Thats actually the one I was looking at! didn't realise it was already supported.
Any idea where its all documented? Checked the ECUMaster section of the "Manual" subforum and couldnt see info regarding the keypad
Re: CAN Keypad as selector?
Posted: 16 Feb 2023, 03:10
by zeroto60
just wanted to bump this if anyone has the info on setting up the can keypad for selector input
Re: CAN Keypad as selector?
Posted: 17 Feb 2023, 17:50
by Renniks
zeroto60 wrote: 16 Feb 2023, 03:10
just wanted to bump this if anyone has the info on setting up the can keypad for selector input
I'll be downloading the Tunerpro software soon and having a proper dig around to see if I can find any presets. Would certainly be nice to see the documentation though, rather than just risking it and buying all the hardware and hoping it works togeather
Edit: No luck. Think its gonna be buy it all and figure it out after!