I am over 800nm with a 8HP70. Using Lamik and Maxxecu.
Maxxecu has a shift cut which allows me to retard timing based in table formats, but please tell me how Lamik sends reduction 0-5000 signal...
In TunerPro there is:
Torque Reduction Output threshold (88%), so does it just send a simply REDUCTION ON signal in the can frame then? Or does it send a scale of reduction amount, based on NM shown in the torque reduction table? If it is a scale, what is sent over CAN (0 - 5000, of 4400 - 5000)?
Last - Maxxecu only allow table axis from -3276.8 to 3276.7 , so how to convert Lamik Reduction 0 - 5000 to that if I need whole thing?