No gear selection when canbus is connected
-
E46 warrior
- Posts: 8
- Joined: 24 Jul 2022, 22:53
No gear selection when canbus is connected
M
Last edited by E46 warrior on 09 Jul 2023, 22:24, edited 1 time in total.
E46 engine + zf8hp mitsubishi warrior
-
E46 warrior
- Posts: 8
- Joined: 24 Jul 2022, 22:53
Re: Fault code 33 and 21 on test
I haven't wired can1/2 into the tcm yet also no rpm signal from the engine ecu mybe this is related 
E46 engine + zf8hp mitsubishi warrior
-
E46 warrior
- Posts: 8
- Joined: 24 Jul 2022, 22:53
Re: Fault code 33 and 21 on test
E46 warrior wrote: 01 Jul 2023, 04:05 I haven't wired can1/2 into the tcm yet also no rpm signal from the engine ecu mybe this is related
Iv just done a test on the wirering loom no problems continuity between pin71band pn 10 transmission plug
But did do a test on pin 10 on the transmission itself and the body of the gearbox and it belled back as continuity
Does this mean the transmission needs to come out again or is the speed sensor grounded anyway
Either way it needs to be done any help from anyone would be greatly appreciated
E46 engine + zf8hp mitsubishi warrior
-
E46 warrior
- Posts: 8
- Joined: 24 Jul 2022, 22:53
Re: Fault code 33 and 21 on test
Checked pin 10 from transmission itself and i have continuity from pin 10 transmission to ground body casing of the transmission does any one have a zf8hp70 transmission to check pin 10 to see if it has continuity to the transmission case this would really narrow down my fault thanks anybody 
E46 engine + zf8hp mitsubishi warrior
-
E46 warrior
- Posts: 8
- Joined: 24 Jul 2022, 22:53
Re: Fault code 33 and 21 on test
Tundra out to be a bad pin connector not making contact withe the TCM
E46 engine + zf8hp mitsubishi warrior