TCU TurboLamik

HOW TO MAKE CAR GO SOFTLY INTO GEAR & ROLL OUT WHEN START: CLUTCH SLEEP STRATEGY

Make sure you have Firmware 10.71 or newer.
Go to Transmission Cal. -> Gear Start -> Slip Clutch When Start
Enable Clutch Sleep [x]
Adjust the values in parameter Clutch Press Drive & Clutch Press Footbrake off, the value of Clutch press Footbrake off adds to Drive pressure value when footbrake switch is off. Adjust this to your liking..
Make sure Disable Engine RPM is lower than your Idle, and Disable Gearbox Oil Temp is higher than your operation temperature, otherwise strategy will not be applied.

Can you please reupload the picture?

This makes the clutch go to sleep(neutral) while stopped with footbrake on?

Anyone try this or have a copy of the picture of the settings settings?

My current setup puts a load on the engine when stopped in gear D/R causing me ICV adaptation problem. If this setting would make the clutch open with brake is on it would fix my issue.