adaptation issue

[Al_p]

hi i cant seem to get the gearbox to auto adapt i set to program 5 went into manual mode and was driving on about 5-10% throttle going through gears 2 to 7 i had the A appear for about 1 second on the display then nothing since , i have everything working that i am aware of as i have ecumaster black connected through can bus

bit of info to help
ecumaster black through can bus 2 so the turbolamik can see map tps etc..
it is an 8hp50 gearbox
m52b28 turbo 450bhp

my issue for adaptations is it does not seem to be locking in gear and during gear change so it slips when i accelerate i am completely new to this type of software so it will be me who has not done something or something needs to be set up , there is a link to the bin file if this helps below .

https://drive.google.com/drive/folders/ ... drive_link

[Msant020]

Your probably exceeding the max torque for adaptations to occur. Possibly due to inaccurate torque to IQ mapping in ECU.

[Msant020]

Try raising the max torque allowable for adaptations to occur in tunerpro