Several codes and only m6 when in drive

[Nmr_fabrication]

I would say to buy a cheese whiz can of 'Right Stuff' and cover it with that. If you epoxy it you'll be looking for a new backplate if you need to get in there. I normally a lay a catapiller over the solder areas and seal it up and put a bit over the hole on the pcb to keep fluid out. The fluid by itself is ok you just want to keep any metal bits from building up on the contacts.

Thanks.
SOLVED
Have put some good window sealant over the solders. And closed the holes.

Everything is working now!
Did the first testdrive, but need to do the calibration, so im going to work this out.
Just got one question about setting up a map i will make a new topic.

So solution in my case,

Changed the mechatronics en solder a new pcb in.
After measuring I got a broken vss sensor.