Hi
it is possible to configure an output that looks like this, for example:
0V - neutral
1V - Gear 1
2V - Gear 2
a.s.o
For me, this is the easiest way to show a gear on my CANchecked display.
or can you configure a CAN output?
Tom
Actual Gear output
-
Luki
- Posts: 40
- Joined: 18 Aug 2021, 12:27
Re: Actual Gear Analog output
You can use one of the four analog outputs
Pin: 46, 47, 48, 50
go to options: Output>>Analog Output
in the "Gear Out Analog" set the analog output
in the "Gear Output Voltage Table" set the voltage you want on the analog output.
Pin: 46, 47, 48, 50
go to options: Output>>Analog Output
in the "Gear Out Analog" set the analog output
in the "Gear Output Voltage Table" set the voltage you want on the analog output.
You do not have the required permissions to view the files attached to this post.
-
Luki
- Posts: 40
- Joined: 18 Aug 2021, 12:27
Re: Actual Gear Can Out
You can send the Can frame to the CAN2 bus
Activate the "CSB V3 ID + 2" frame
The standard address of this frame is Decimal: 1600 + 2 = 1602
Byte0:
FE-P
FF-R
00-N
01-1
-----
08-8
Activate the "CSB V3 ID + 2" frame
The standard address of this frame is Decimal: 1600 + 2 = 1602
Byte0:
FE-P
FF-R
00-N
01-1
-----
08-8
You do not have the required permissions to view the files attached to this post.