Actual Gear output

[Tom]

Hi

it is possible to configure an output that looks like this, for example:

0V - neutral
1V - Gear 1
2V - Gear 2
a.s.o

For me, this is the easiest way to show a gear on my CANchecked display.

or can you configure a CAN output?

Tom

[Luki]

You can use one of the four analog outputs
Pin: 46, 47, 48, 50

go to options: Output>>Analog Output

in the "Gear Out Analog" set the analog output
in the "Gear Output Voltage Table" set the voltage you want on the analog output.

Gear analog output.jpg (331.84 KiB) Viewed 2335 times

[Luki]

You can send the Can frame to the CAN2 bus

Activate the "CSB V3 ID + 2" frame
The standard address of this frame is Decimal: 1600 + 2 = 1602
Byte0:
FE-P
FF-R
00-N
01-1
-----
08-8

Gear CAN.png (118.97 KiB) Viewed 2335 times

[Tom]

Thank you!